Gear motor for sliding gate 400kg 230v FAAC 746 ER Z20 109773

Gearmotor in oil bath FAAC 746 ER Z20 230V code 109776, Z20 pinion version, with higher speed than the Z16 version but with a lower capacity, for sliding gates up to 400 kg in weight, with electronics and encoder included that offer maximum safety on anti-crushing also optimized by the two-disc mechanical clutch also in oil bath.

Release system with European pawl and lever to facilitate movement. Magnetic limit switches. Compatible with the replacement of the old model FAAC 746 EMC.

Built-in 780D 230V electronics with encoder management and obstacle reversal, equipped with all the inputs and outputs necessary for installation.

What's in the box for the 746 ER engine from FAAC?

• N. 1 Gear motor 746 ER Z20
• N. 1 Electronics 780D
• N. 2 Magnetic limit switches
• No. 1 Installation Manual

What are the technical characteristics of the 746 ER engine of the FAAC

• Mains supply voltage: 220-240V~ 50/60 Hz
• Electric motor: Single-phase asynchronous
• Max power: 400 W
• Max torque: 26 Nm
• Max thrust force: 650 N
• Reduction ratio: 1:30
• Max leaf width: 50 m
• Leaf speed: 12 m/min
• Speed Adjustment & Motor Control: No
• Limit Switch: Magnetic
• Sprocket: Z20 module 4
• Encoder: Magnetic Encoder
• Force adjustment: Twin-disc clutch in oil bath and via board
• Ambient operating temperature: -20°C ÷ +55°C
• Thermal protection: 120°C
• Degree of protection: IP44
• Weight: 14 Kg
• Oil Type: FAAC HP OIL
• Dimensions (LxWxH): 277 x 155 x 337 mm
• Maximum leaf weight: 400 Kg
• Frequency of use: 70%