PASS 621 Operator for sliding gates 600 Kg in oil bath without central unit

This type of operator fully replaces the old models of PASS 4 and 6. This is the version without an on-board control unit with only the limit switch board, so it requires the system to be equipped with a separate control unit.

Some older models of the GIBIDI called SL400 with a 230V motor had a different cover but in reality they were PASS and can be replaced in all respects with the new PASS641E. If the original foundation plate was walled up during the installation of the old SL or old PASS GIBIDI there will be no need to replace it and therefore the original one will be fine. If you need to replace it, you will have to buy the AJ92190 accessory.

WARNING: the anchor plate is not included in the package, which must be purchased separately if necessary. If you are buying this operator to replace an old PASS, you can reuse the old anchor plate, the distances are the same.

GENERAL DESCRIPTION PASS 600 - 800 SERIES:

Irreversible electromechanical gear motor at 230 vac for medium-sized and heavy sliding gates (up to 600 Kg) suitable for residential and condominium use.

EASY TO INSTALL
Possibility of adjustments on the horizontal and vertical axis.

QUIET AND ROBUST
Made with gears of considerable size, heat-treated and in complete oil bath. Painted aluminum body that guarantees reliability over time.

PERFORMING
Special engines in oil bath for excellent performance even with heavy use, versions with twin-disc mechanical clutch. New irreversible and anti-slip gear unit.
DESIGN

The most compact in its class thanks to the direct horizontal motor, only 10 cm thick.

SPECIFICATIONS:
Use: INTENSIVE
Frequency of use: 0.6
Motor power supply: 230 Vac - 50/60 Hz
Power consumption: 350W
Degree of protection: IP55
Speed: 160 mm/s (9.6 m/min) - Z=16 M4
Max torque: 20 Nm
Max. leaf weight: 600 Kg
Operating Temp.: -20°C +60°C
Thermal protection: 140°C
Lubrication: GBD PH-01 OIL
Operator weight: 11 Kg