Remote Control Transmitter Era One 4 channels NICE original ON4E

NICE ON4E was One

1, 2, 4, 9-channel transmitters and plug-in receivers, pre-wired, with and without built-in transmitter.
433.92 MHz rolling code, management of Enabling Codes and Certificates, self-learning and integrated proximity receiver; with 72-bit O-Code encoding, also compatible with NICE FloR encoded receivers.
Also available in multiple insertion sequential encoding versions (Era OneC).
Evolved: it uses calculation and recognition systems that increase the degree of safety and reduce the response time of automation by about 3 times.
Practical to memorize, even from a distance: thanks to Opera receivers.
Safe: in case of theft or loss of a transmitter, it is possible through O-Box to replace it while maintaining the same functions as the previous one and disable the old transmitter, increasing the priority level on the new Era One.
Without going near the plant it is possible to enable a new transmitter in two different ways:
using a transmitter already enabled in the receiver, thanks to the exchange of the Enabling Code between the two;
through the multifunction interface NICE O-Box you enter the Certificate of the receiver simply by bringing the new transmitter close to O-Box and starting the wizard from PC or PDA.
Very practical: the Era OneC version allows, through the O-Box programming unit, to store entire packs of 10 pcs in a single operation, without having to open them.
Elegant and comfortable: the Era One transmitter can be used as a refined and technological key ring or fixed to the wall or dashboard of the car thanks to the convenient support (ONECLIPKIT).
It was OneFM, ideal for use in cities or places with the presence of many devices.
Line of 868.46 MHz transmitters, Rolling Code that use FM frequency modulation, which guarantees greater immunity to interference.

Duplication must be carried out in the vicinity of the receiving unit.

1. Press for about 5 seconds the button you want to encode of the new remote control.

2. Press the working remote control button 3 consecutive times.

3. Press the new remote control button again.

Wait at least 10 seconds and try to operate the gate opening with the remote control just programmed.

To duplicate other remote controls, repeat the operation starting from step 1.

If the procedure is not successful or if mistakes are made during programming

Wait 20 seconds and restart the programming operation from step 1.

SPECIFICATIONS:
Carrier frequency: 433.92MHz
Estimated range: 200 m (outside); 35 m (if inside buildings)*
Encoding: O-Code 72 bit; rolling code
Power supply: 3 Vdc; lithium battery type CR2032
Battery life: 2 years (with 10 transmissions per day)
Degree of protection: IP40 (use in protected environments)
Dimensions: 45x56x11 h mm
Weight: 18 g

Warranty 24 Months